======================
1.How to update s/w by PC?
======================
1) Prepare a twisted RS232C cable(pin-2 to pin-3,pin-3 to pin-2,pin-5 to pin-5).
2) Connect your PC and receiver with twisted RS-232C cable.
3) Power off your receiver.
4) Run EasyUpgrade.exe on your PC,click <Start>,then Power on the receiver,the upgrade will start.
5) When finish, the LED will display "-End" ,then restart the receiver.

============================
2.How to update receiver to receiver?
============================
1) Prepare a twisted RS232C cable(pin-2 to pin-3,pin-3 to pin-2,pin-5 to pin-5).
2) Connect the master receiver and the slave receiver with twisted RS-232C cable.
3) Turn on the master receiver and press "POWER" key to make it standby, the LED dot will blink.
4) Turn on the slave receiver,then the LED of master receiver will display 'H'.
5) Input digit number on master receiver to update different parts:
	 111---- Update software.
	 222---- Update data.
	 333---- Update data,then software.
	 444---- All flash except boot loader. 	
6) When finish, the LED  will display "-End"

======================
3.How to Edit Patch key?
======================
  if patch is enable:
  1) Key menu:Main Menu-->Installation-->Other Setting->Input Code
  2) Current Key: INFO+0
  3) All ECM List: INFO+1


======================
4.How to update the Patch key?
======================
1) Download the softcam.key from the internet.  You can go to http://byksat.kabel1.cz/dreambox/dreambox.html to download the softcam.key
2) Prepare a twisted RS232C cable(pin-2 to pin-3,pin-3 to pin-2,pin-5 to pin-5).
2) Connect your PC and receiver with twisted RS-232C cable.
3) Turn on the receiver and press "POWER" key to make it standby, the LED dot will blink.
4) Run the update tool on your PC,Slect the <Download Key>,press <Open> and select the softcam.key  file,then click <Start>,upgrade will gin.
5) After finishing, the LED will display "-End"


======================
5.Special function of RS232 sharing
======================
1) Prepare two receivers,one for CA,and one for FTA.
2) Prepare a twisted RS232C cable(pin-2 to pin-3,pin-3 to pin-2,pin-5 to pin-5).
3) Connect two receivers with twisted RS-232C cable.
4) power on two receivers,press info+9(with channels exist),then will show a uart list.
5) the CA receiver select the "Master RS232 sharing",and the FTA receiver should select the "Slave RS232 sharing",then the master receiver will share Ca card with the FTA receiver.The FTA receiver should make patch enable.


